Aviom AllFrame User Manual download pdf (Page 58)

f6 fr o n T Pa n e l Co m P o n e n T s

ALLFRAME

™

Multi-Modular I/O System

I/O Card Cover Plates

Metal cover plates ship with the F6 Modular I/O Frame covering the I/O expansion card slots. To remove a cover

plate, use a #1 Phillips screw driver or 3/16-inch hex nut driver. Retain the cover plates and screws for future use.

See page 11 for additional information about installing I/O cards in the F6.

P No t e : Keep the cover plates on when I/O cards are not installed to protect the F6 backplane area.

I/O Card Label Area

Each I/O card used with the F6 Modular I/O Frame contains an area that can be used for channel labelling.

Permanent custom-made labels can be created and affixed to the area using 2- or 3-ply laminated engraving

stocks (sometimes branded as “Lamicoid”). The engraved labels can be secured with stick-on adhesive or with

screws using the built-in threaded mounts

P No t e : When adding custom-made labels to an I/O card be sure to measure correctly so that the finished labels

do not interfere with the operation of the XLR I/O connector’s lock tabs.

The area available for affixing engraved laminated labels measures 4.2 x 0.5 in. (106.68 x 12.7 mm).

The label area also includes threaded connectors that can be used to secure patch bay style label strips or

engraved multi-ply plastic laminate labels. The threaded inserts are PEM FEOX-440 which accept a #4 machine

screw with 40 threads per inch. Maximum screw length is 0.25 inch.

The diagram that follows can be used as a guide when creating custom labels for the I/O cards. The area shown in

red is the suggested maximum size for a laminate label; note that clearance must be allowed for the tabs on the

mic input XLR jacks to operate freely.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 110 111

No comments

Aviom AllFrame User Manual Page 58